Got water in the plugin on the oil level sensor. Low level light stayed on. Unplugged switch blew water out plugged back in. Been fine, gonna go out and put some dielectric grease in there right now.
Vent on the clutch side panel didn't have any clips installed to hold in place, took 2 clips off the muffler side and put on the clutch side , been fine since.
Exhaust side panel rubs on fuel tank and wire harness plug. I put aluminum tape on there to see if it would slow down the wear.
Fuel tank had a sharp edge (seam) that was chafing the fuel line, i took a file and smoothed the seam.
Put tape on the intake vents. Manufacturer tolerances way out of spec on the top piece(top vents, gauge mount, windshield mount) causes a bow in the plastic when bolted to the intake. I used aluminum tape cause the glue residue is easier to remove than duct tape. Hoping cat will provide a correct fitting part....
440miles, 35hrs. Not a lot of trail riding.
Alpha Cat......