Ok, did a fairly major revamp on sled and now have it all together, (subframe removal, so all wiring was moved quite a bit). I started the sled and took a spin in the yard, all was well. Dropped the oil and when I went to restart after changing oil the fuel pump will not engage. I can feel the relay clicking, so I am pretty sure it is good, i can also put a jumper to the fuel pump and make it run. I have torn it apart again and wiggled the main harness, checked connections (all have dielectric grease in them) at the relay and the ECU, with the key on I cannot get the pump to come on at all.
I aslo have rocks grip booster on it and the rollover valve, and neither one of them are working either. The rollover tether does kill the juice, but the valve does not close and the light on the dash does not come on. The handwarmer booster does not light the dash light either when the grips are turned off (like it should)
I am leaning towards something in the ECU unless someone can steer me in the right direction.
The sled ran fine right up until I shut it off to change the oil, and now nothing but cranking and code 43 which I know is the fuel injection system.
Thanks for any help.
Kirk
I aslo have rocks grip booster on it and the rollover valve, and neither one of them are working either. The rollover tether does kill the juice, but the valve does not close and the light on the dash does not come on. The handwarmer booster does not light the dash light either when the grips are turned off (like it should)
I am leaning towards something in the ECU unless someone can steer me in the right direction.
The sled ran fine right up until I shut it off to change the oil, and now nothing but cranking and code 43 which I know is the fuel injection system.
Thanks for any help.
Kirk