S
I have an 06 fusion 900, have been chasing electrical issue for over a week now including removing the motor twice and checking stator.
With chassis relay plugged in the engine starts, idles up, very week lights, no mfd.
Unplug chassis relay runs perfect just no lights and no mfd.
Have tried three new chassis relays all with the same result.
Tested capacitor, 12.16 volts and slowly diminishes the longer I have the meter on it.
Tested stator and ohms out perfectly. Removed motor and stator, no busted wires, flywheel housing is still glued in tight.
started sled without chassis relay in place and checked voltage regulator and getting 13.5 volts at idle and very small increase as I increase the rpms.
Removed MFD wiring harness and inspected, no busted wires, no exposed wires.
Completely loss as to the cause of my problem and any help would be greatly appreciated.
With chassis relay plugged in the engine starts, idles up, very week lights, no mfd.
Unplug chassis relay runs perfect just no lights and no mfd.
Have tried three new chassis relays all with the same result.
Tested capacitor, 12.16 volts and slowly diminishes the longer I have the meter on it.
Tested stator and ohms out perfectly. Removed motor and stator, no busted wires, flywheel housing is still glued in tight.
started sled without chassis relay in place and checked voltage regulator and getting 13.5 volts at idle and very small increase as I increase the rpms.
Removed MFD wiring harness and inspected, no busted wires, no exposed wires.
Completely loss as to the cause of my problem and any help would be greatly appreciated.