2011 Chaincase To belt drive

[NapaMatt]

2011 Polaris Pro 155"

Has stock gearing now

looking to cheaply conv. to Belt Drive

I can reuse my drive shaft. Caliper

I will need a 2013 to 2015..

JackShaft Brake Rotor
Top Gear
Bottom Gear
Belt
Backing plate


Seeing some flip a rotor.. is it needed with jack shaft change?

If i do have to change out backing plate for the belt drive. It can be done. But wanted to keep it in..

IF any one has done the conversion let me know

Huge Thanks! Matt

 

[sledtahoe]

why bother?

 

[NapaMatt]

Id like to have the belt drive.

one less fluid to leak out..

I can stick with the chain case too.

But have ridden a few belt drives now,, and i want it!

 

[NapaMatt]

Done Deal!!

Took Off the chain case, Put on a Belt drive from a 2015 Pro

Also went with the anti ratchet drivers, 7 tooth. From the stock 8. Everything lined up well.

If any one has blow a belt or heard a clunking noise. Id check behind ur top gear.. Make sure you have a good shaft.

Can't wait to try her out!!

 

[Teth-Air]

TKI did make a kit for this but now I believe Tom just sells the 13+ kit so you will have to put on a QD backing plate for his kit.

 

[NapaMatt]

yea. i could have gone that route.. but this was much cheaper!!

Under 400!$$