F
f7firecatkid
Well-known member
could you post up more pics? havnt gotten mine yet lol
B&M Fabrications Arctic Cat ProClimb Skinny Board Pre Order
- Thread starter B&M Fabrications
- Start date
We will do install instructions here when I get some of the boards at coating back. The sled we have in the shop is still boardless too.
Sent from my SM-G928V using Tapatalk
Sent from my SM-G928V using Tapatalk
I think so
I just need to upload the video s, had to do 3 different ones, not very good but it will help
F
f7firecatkid
Well-known member
No I'm waiting on gloss black. Think the powder coater is being special.
I ordered orange as well - BMFab PM'ed me on here and said they should be shipping out by the end of the week!
F
f7firecatkid
Well-known member
lucky
F
f7firecatkid
Well-known member
Finally got mine in the mail today. Anyone have install pics or videos tip tricks etc
PM Wyoboy1000. Maybe he can get the vids he made uploaded. Notice how we cut the boards. We leave the riveted section intact for structural strength. I posted a bunch of other pics and steps already as well. Jig saw worked better than plasma cutter. Also use an angle grinder with sand wheel then die grinder with fiber wheel to clean up the edges and make smooth. Also I masked off and spray painted and clear coated the edges for a finished look.
***The Steel chassis rivets drill easily if you do this first***
FWIW; The steel chassis rivets drill easily if you take a small punch and drive the Hardened mandrel down about an 1/8" first. Driving the hardened mandrel down the 1/8" lets you drill the head off and then you can knock the rest out.
It is the same functionally as grinding the head off but doesn't destroy the panels that are riveted, if you need / plan on reusing them.
FWIW; The steel chassis rivets drill easily if you take a small punch and drive the Hardened mandrel down about an 1/8" first. Driving the hardened mandrel down the 1/8" lets you drill the head off and then you can knock the rest out.
It is the same functionally as grinding the head off but doesn't destroy the panels that are riveted, if you need / plan on reusing them.
Very helpful Wyo/CO - hopefully you can get the rest of the videos to load.
Thank you!!!!
My way is way faster on this because you don't use anything you grind. and the ones on the board are at an angle and just pi$$ you off trying to get straight.
Not the best video but better then nothing.
Part 1
https://www.youtube.com/watch?v=B4cjaR_5pRI
Part 2
https://www.youtube.com/watch?v=eJ7ixTVTVOc
Part 3
https://www.youtube.com/watch?v=0DDPHo1noew
Part 1
https://www.youtube.com/watch?v=B4cjaR_5pRI
Part 2
https://www.youtube.com/watch?v=eJ7ixTVTVOc
Part 3
https://www.youtube.com/watch?v=0DDPHo1noew
Last edited:
Getting a huge batch back from powder in the morning and shipping all day tomorrow. If I'm lucky enough to have a set left over to put on the sled in my shop I will make some directions to compliment WYOS videos. Sorry for the delays boys and girls, busy time right now and new products have quirks with getting them right for building. Have some new equipment coming in to help us produce more, better, and faster. We appreciate your patience with us, I assure you that we work as hard and as much as anybody else...no casino, bar or working personal projects in our lives yet.
Sent from my SM-G928V using Tapatalk
Sent from my SM-G928V using Tapatalk
Similar threads
