Finally got my M1000 Twisted Turbo out this weekend for some testing and for the life of me I can not figure out the gurgle and cut out the sled was experiencing. Below are some facts:
VP110 pre mixed 40:1
8-9k elevation
9LB Boost
40psi fuel
2500 miles Reeds and Pistons Replaced at 1600mi
Starts after about 5-6 sometimes 7 pulls, Starts 1 pull warm
Idles fine
12.3AFR on full boost
I have tried every single combo known to man on the box and no matter what I do the top end "retards" and is not clean. The bottom end loads up and gurgles then cleans itself out. If I'm on the throttle on and off it will cut off for a second every once in a while at mid-full throttle then pick itself back up (almost puts you over the bars with it happens). I'm thinking it's reeds and possible pistons? I have not done a compression check. And yes I am going to go to the Boost-it box, but I don't think the box is the problem maybe it is? Any help would be greatly appreciated!
VP110 pre mixed 40:1
8-9k elevation
9LB Boost
40psi fuel
2500 miles Reeds and Pistons Replaced at 1600mi
Starts after about 5-6 sometimes 7 pulls, Starts 1 pull warm
Idles fine
12.3AFR on full boost
I have tried every single combo known to man on the box and no matter what I do the top end "retards" and is not clean. The bottom end loads up and gurgles then cleans itself out. If I'm on the throttle on and off it will cut off for a second every once in a while at mid-full throttle then pick itself back up (almost puts you over the bars with it happens). I'm thinking it's reeds and possible pistons? I have not done a compression check. And yes I am going to go to the Boost-it box, but I don't think the box is the problem maybe it is? Any help would be greatly appreciated!