no snow on the ground so i am here .
over the years we get a few that have a problem fitting cans in there sleds .
the fit is very tight and we are trying to keep the main pipe sitting properly .
were the can slides down on the rail were the rubber is there is a small rubber tit extending above the rail , apx 1/4 inch , can shave this off to get the can to sit a lottle lower if you like .
watch that the main pipe is coming back to its original place .there are two front springs that can pull the main pipe forward and make the install not seem correct.
useing the two left over spring at the bottom of the can , spring down in a v shape to the inner rail, at the bottom of the can , this helps keep it straight when used .
we have had guys buy them and when there in town to sled stop in and ask us to install them as they couldnt figure it out . takes us a minute and normally the guys asking what he was doing wrong . is were we found that it can be hard to fit as it is a very tight fit .
early xp cans were off a bit on the exit cone but only i think the first 10 or so
changed the jig and since then it has been good.