N
Hi guys have to pull the motor. Can't seem to find a step by step process.
In any of the links. Any tips would be great.
Also would you repair a hole in the case about 1/2 inch round in between the the bell end on the crank in an area there is clearance? I have the gear and experience to weld alum? Dropped a peace of skirt and it blow out.
Or look for a new bottom end.
Cheers.
In any of the links. Any tips would be great.
Also would you repair a hole in the case about 1/2 inch round in between the the bell end on the crank in an area there is clearance? I have the gear and experience to weld alum? Dropped a peace of skirt and it blow out.
Or look for a new bottom end.
Cheers.