just because I spent some much, and did so much research here's the build list overview for anyone that is on the CR5 path for reference:
MRE TWIRP case porting/cylinder mods/head mods w/decompressor/billet covers and exhaust flange/custom billet reed spacer for vforce2
Rekluse z-start pro with 27 tungsten balls and m4 spring with makita billet basket - hymec hydro clutch
ricky stator 40w lighting coil for cr250 modified to fit, cr250 flywheel and cr125 digital ignition - trial tech voltage regulator and ktm lipo battery
Koso egt/rpm/temp gauge
Home made coolant heated bars with a pex tube running end to end for distrobution of heat / mounted with Mako 360 full rubber isolation rubber bar clamp
Avid carb heater and thermostat on Lectron 44HV with custom intake made form turbo hose and aluminium tube drilled with hole saw - filter wears
CPI racing is making me a custom pipe that should be done shortly
engine jackets will be made later this month at the canvas shop
tunnel cooler is off an EXT580 artic cat, HPS hoses, crimp on hose binders unless a maintenance area hose fitting, then Norco hose clamps (the best!)
Forks i'm valving stiff - pro sx stack, .60 springs and I added schrader valves to charge with a few psi for bottoming
Stegs pegz - excited for the hill climbs with these little things. rubber calve rests for your boots to get the load off your arms on big pulls
Throttle Jockey original McGrath 1995 race graphics and seat cover kit
CRF newer plastics on number plates and fenders
18 ARO LE 120 kit ran it last season on a 16.5 ktm450 SXF FE