H
Cant seem to find the sweet spot with setups ive been trying. I have a 2002 800 Edge RMK: SLP ported cylinders,cut head,reprogrammed cdi,reeds, SLP race pipes. HRP rolled case, 19/43 gearing, running Camo Extreme 156"x16"x2.5"x3.0 pitch. Run 400-410 mains around 5-7k
My problem is im not getting to that magical 8150-8200
Primary setup: Brand new P-85 w/ 10-64's SLP Blue/Pink (140-340)
Secondray setup: R8 helix w/ yellow spring think its an ArcticCat spring(not sure)
Hole 1-7500
Hole 2-7800
Hole 3-7800
Hole 4-7900 (Best setup so far)
Secondary and belt pretty hot after few long hard pulls
2nd Secondary setup: SLP 46/34 w/ EPI orange spring
Hole 1-7700
Hole 3-7500
Hole 5-7100
Secondary and belt pretty hot after few long hard pulls also just couldnt seem to get this setup to work that well but was supposed to be the cats MEOW.
Just trying to get some different suggestions as im no clutching expert but the only thing ive been told is it should pulls the 10-64's and going to 10-62's willl get my rpms up but i lose the pull (torque) lets here some thoughts guys!!!
My problem is im not getting to that magical 8150-8200
Primary setup: Brand new P-85 w/ 10-64's SLP Blue/Pink (140-340)
Secondray setup: R8 helix w/ yellow spring think its an ArcticCat spring(not sure)
Hole 1-7500
Hole 2-7800
Hole 3-7800
Hole 4-7900 (Best setup so far)
Secondary and belt pretty hot after few long hard pulls
2nd Secondary setup: SLP 46/34 w/ EPI orange spring
Hole 1-7700
Hole 3-7500
Hole 5-7100
Secondary and belt pretty hot after few long hard pulls also just couldnt seem to get this setup to work that well but was supposed to be the cats MEOW.
Just trying to get some different suggestions as im no clutching expert but the only thing ive been told is it should pulls the 10-64's and going to 10-62's willl get my rpms up but i lose the pull (torque) lets here some thoughts guys!!!