M
I have a 13 cat with a few mods just picked this one up this season
Stage 2 kit so
Full Jaws exhaust
BD Fuel controller
V force 3 reeds
Dalton clutch kit with helix and both springs
So sled works amazing pulls 8450 for rpm sometimes consistent on pulls for over 10 seconds and other times I can watch the rpm go 82 8 78 76 all the way down to 69 or until I let off the throttle and hit it again then it will jump to 8450 again and lose its rpm again in the same pull.
Tired primary spring or over weight in primary ?
Pulled some weight out and got my rpm from 82 to 8450 ( where it should be with the exhaust ) but still only holds peak rpm 40% of the time almost feels like the primary spring is binding up
Any input , just got off the mountain and haven't tore into anything yet
Stage 2 kit so
Full Jaws exhaust
BD Fuel controller
V force 3 reeds
Dalton clutch kit with helix and both springs
So sled works amazing pulls 8450 for rpm sometimes consistent on pulls for over 10 seconds and other times I can watch the rpm go 82 8 78 76 all the way down to 69 or until I let off the throttle and hit it again then it will jump to 8450 again and lose its rpm again in the same pull.
Tired primary spring or over weight in primary ?
Pulled some weight out and got my rpm from 82 to 8450 ( where it should be with the exhaust ) but still only holds peak rpm 40% of the time almost feels like the primary spring is binding up
Any input , just got off the mountain and haven't tore into anything yet