Extended Nytro Mtx

wwillf01 · Nov 4, 2013

I have a 2008 Nytro Mtx

So I ordered a new track to extend to a 162. It is a Camoplast Extreme 2.25... When it went on it is so tight that I have to leave the adjustment nuts off the rear of the stock skid..... All I did was add the track with extensions...At that I really have to squeeze two fingers I between the skid and track. Do you guys think when I do some test runs with the new turbo the track should stretch and inch or so... That way I can put the nuts back on?

Sent from my iPad using Tapatalk HD

Sent from my iPad using Tapatalk HD

TRUEBLUEMAX · Nov 4, 2013

I would check and make sure everything is right on there. Sounds like you may have gotten the wrong extensions. I would not run it that tight.

wwillf01 · Nov 4, 2013

TRUEBLUEMAX said:
I would check and make sure everything is right on there. Sounds like you may have gotten the wrong extensions. I would not run it that tight.

SO I am double checking the work of the
Yamaha dealer locally... You think that is the case? It seemed weird to me.. See pic..

https://www.dropbox.com/s/jj8iayce4px57o5/2013-11-04 09.13.07.jpg

up-high · Nov 4, 2013

You should only need another 4.5 inches of rail(assuming you went from 153 to 162). Loosen the rear axle and suspension completely to relax the track and make sure the track is centered and the wheels run between the rubber nubs. Should be able to put the track tensioner nuts on at least. Measure from the old axle center to the new center location. Maybe someone looked at the tape wrong?

Search

Extended Nytro Mtx

wwillf01

Well-known member

TRUEBLUEMAX

Well-known member

wwillf01

Well-known member

up-high

Well-known member

Similar threads