D
First off, I cannot for the life of me figure out the tail lights. 3 wires. Orange, yellow, and brown.
I spliced a power wire to the yellow and it lights up but not brake light, I can't get it to light no matter what.
I touched the 12v wire to orange and then the brake light on the dash comes on and turns off when I pull on the brake. I did the splice just for safety. Needed something lit up on the back of the rig.
On the handlebar side of things. I have tested the orange wire and has power When I ground it to the bars. It has nothing for power if I test the orange to brown connector. If I use a jumper wire between orange and brown, I still get nothing. I thought since it was grounded, it should have voltage.
I also changed out the brake switch with no cure.
Then the hand warmers have not power getting to them. The tiny lights are on next to the switches. I took apart the switch block internally. Looked pretty good.
I also ran power to the grips and spliced in an on/off switch. The heaters are set to medium. I changed one out as it had a burn through the plastic.
Is this a ground issue? I know of the main ground by the left footwell is good. Where else are ground wires.
Are all of these components hooked together or something?
Sorry I'm a rookie at this stuff. I know someone will come through for me.
Thanks all
Dman142
I spliced a power wire to the yellow and it lights up but not brake light, I can't get it to light no matter what.
I touched the 12v wire to orange and then the brake light on the dash comes on and turns off when I pull on the brake. I did the splice just for safety. Needed something lit up on the back of the rig.
On the handlebar side of things. I have tested the orange wire and has power When I ground it to the bars. It has nothing for power if I test the orange to brown connector. If I use a jumper wire between orange and brown, I still get nothing. I thought since it was grounded, it should have voltage.
I also changed out the brake switch with no cure.
Then the hand warmers have not power getting to them. The tiny lights are on next to the switches. I took apart the switch block internally. Looked pretty good.
I also ran power to the grips and spliced in an on/off switch. The heaters are set to medium. I changed one out as it had a burn through the plastic.
Is this a ground issue? I know of the main ground by the left footwell is good. Where else are ground wires.
Are all of these components hooked together or something?
Sorry I'm a rookie at this stuff. I know someone will come through for me.
Thanks all
Dman142