I had issues with the secondary adjuster backing out last year on my '05 M7 so I was going to put a set screw in the cover to keep it from backing out. I was just wondering if anybody that had done this could tell me the best way to do it???
Would it work better to put the screw in like a normal set screw where it pushes into the plastic adjuster, or would it be better to put the screw through the cover and "in front" of the adjuster to keep it from backing out?
Also would it be better to put in 2 set screws or just one? That and should I use a small tap and machine screw or would a self-tapping sheet metal screw work?
Photos would be lovely if anybody has them. Thanks!!!!
Would it work better to put the screw in like a normal set screw where it pushes into the plastic adjuster, or would it be better to put the screw through the cover and "in front" of the adjuster to keep it from backing out?
Also would it be better to put in 2 set screws or just one? That and should I use a small tap and machine screw or would a self-tapping sheet metal screw work?
Photos would be lovely if anybody has them. Thanks!!!!