Just wondering what everyone is using, or planning to use, 082, 083 or 084? Have a Team Tied on the way for next week, but need to buy a spare belt for this weekend. Just curious if I should go with the 084 or is the cheaper 082 just as good with this setup?
What recomended belt with the Team Tied setup?
- Thread starter machz9805
- Start date
If you are running an 1100 stick with the 082.
If you are on the 800, 084 or 086 work.
If you are on the 800, 084 or 086 work.
What If you we're destroying the 082 stock, or your ctc is more than 11.5. is the team a smaller clutch?
If your center to center is more than 11.5" it needs corrected. In order to work correctly you have to have it right.
The Team is a larger diameter, but it is only a slight difference.
The Team is a larger diameter, but it is only a slight difference.
How would you go about correcting the center to center on this sled if it were too long?
N
nosajlleb
Well-known member
Trillion dollar question! Take off tcl and bend it in vise.
I don't have a team but I shimmed my primary and now run the gates carbon that fits the the old T660 from 2005.
Last edited:
Most that I have seen have an issue with parallelism. The motor is down and back on the right side and this pulls the end of the crank forward to extend the center to center. The motor then has to move.
As you guys have stated, you can't "adjust" the TCL.
As you guys have stated, you can't "adjust" the TCL.
I have a 11.6 c to c, and switched to the XS809. It is about a half inch longer than the 082, resulted in cooler secondary. But I still have the stock secondary, as no one has a team setup for us 0-3000ft (BD set at 19 psi at sealevel) climbers yet.
So the Team Tied setup won't work 0-3000?
