J
I found a few areas to drop parts from the new XP's.
Remove plastic from belt gaurd and trim alum tabs off.
Remove tool kit holder and store under seat. Cut white plastic center bar from square opening under seat to allow the took kit to unroll, then hook toolkit under plastic tabs. (sorry no pics)
Tear off all foam, leave the heat foam on the right side for high temp can.
Remove plastic sound gaurd from right side of motor. I striped the foam off then cut it down to and reinstalled it to keep hoses and wires from bouncing around.
Cut lower section from rear flap.
Drilled out the top of right foot well.
Remove plastic from belt gaurd and trim alum tabs off.
Remove tool kit holder and store under seat. Cut white plastic center bar from square opening under seat to allow the took kit to unroll, then hook toolkit under plastic tabs. (sorry no pics)
Tear off all foam, leave the heat foam on the right side for high temp can.
Remove plastic sound gaurd from right side of motor. I striped the foam off then cut it down to and reinstalled it to keep hoses and wires from bouncing around.
Cut lower section from rear flap.
Drilled out the top of right foot well.