I recently replaced my worn out control arm bushings on my '17 AXYS RMK Pro. I installed new (brass) bushings, and reinstalled the spacers & retaining ring (#5 in the photo below).
Is it advised to replace the retaining ring as well? Reason being, it doesn't seem to hold the bushing in place, and after a few minutes down the trail, retaining ring blows out of the slot and which allows the control arms to move back and forth on the pivots.
Anyone else have this happen?
Is it advised to replace the retaining ring as well? Reason being, it doesn't seem to hold the bushing in place, and after a few minutes down the trail, retaining ring blows out of the slot and which allows the control arms to move back and forth on the pivots.
Anyone else have this happen?