engine

I just bought a 09 dragon 800 with about 750 miles on the fully rebuilt engine and a new team clutch. I have only been able to get out and ride once since I picked it up. When I was out riding I noticed that when i got into the 6000-8000 rpm range it would just take off, it felt like it hit a...

Hello I'm in need of a long block complete with crank.or a whole motor I live in alaska so Local would be best but we can work it out let me know what u got. Thanks Darren

This is on a 2012 Pro RMK 162 with 953 miles. No Mods Last Saturday (3-2-13) we was riding up in one of my favorite spots when the snow is good. First thing in the morning the sled wouldn't start. Thought it was electrical because I washed it off the evening before and thought maybe a...

I picked up a used motor for my buddies 2003 Ski-doo Summit (zx) out of a 2003.5 Ski-doo rev. We pulled the old motor and set it side by side with the new one and there are a couple obvious differences between the two. First thing I saw was the extra hose fitting on the new head, there isn't...

http://eastoregon.craigslist.org/rvs/3527835463.html I might also add this sled has a clean title, and does not come with the Exit shocks shown in photos, will have the stock X model shocks on them when I get time to do the switch. Located in Eastern Oregon

Hi I'm looking for a motor for my buddy's sled. It blew up a couple weeks ago and the left piston completely grenaded the head, and cracked the lower block. I've done a bit of research in the last week and now know of sea-doo clinic and the work they do. They have a new 800 motor but the price...

i am looking into buying a 2008 polaris 700 rmk,I know the 800 reliability is bad but am not sure about the 700. i currently have a 600. Any thoughts on the 700 engine?

Just rebuilt the engine. Everything was fine on the trail. We got back into the snow and after I would run it for at full throttle up a hill, I would let off and head back down and the engine wouldn't pop back up above 4500. After I sat for a minute it would run fine again till I would max out...

My buddy blew up his sled the skirt broke off the cylinder and cracked the case. The crank is still good so were looking for a complete motor for a 2006 carburated m7. Or crank case and 2 cylinders. Any help would be appreicated. thanks

Need a motor for my 03 Mountain Cat 800 EFI, I think 02-04 the motors were the same. Would also be interested in your wrecked sled if your located in Washington. PM me with what you have.

Sold all! Thanks to all buyers and shoppers, Polaris Dragon 800 Monoblock Cylinder & Crankcase & Crank For 2009 Polaris Dragon 800 cc Used crankcase upper and lower half $300.00 Shipping weight 14 Pounds Used Monoblock Cylinder set $100.00 Need replated GOOD FOR EXCHANGE...

Can anyone tell me if there's a "List of Updates" that should be done to a 2008 RMK 700? I'm not experiencing any problems, but I sometime see people selling a sled similar to mine and they state that all the "Updates" are done. I don't have a lot of faith in my local dealer, so I don't want to...

I have a rack of carbs, boyeson reeds, carb boots, 121" M-10 rails and some PSI pistons for an 800 big bore on a 700 block.

I am looking to install the drop in kit and head for my '10 XP Ptech. Has anyone done this? Do you really gain 12 HP? Did you have to adjust your clutching or jets? Is the ECM Re-program necessary? Let me know the good and the bad of this upgrade... Thanks

anyone have a good crank for a 2005 Polaris 900 or know where i can get bearings pressed on?

SOLD

Im looking for apex motor with low miles for an 07 thanks have guns to trade if interested or cash thanks 406-209-1935

I threw a mag side rod bearing, seized the engine and cracked the blocks. So, Ive got all the part of a 2007 Dragon 700 155" x 2 1/2" track. Motor had about 2400 miles on it. Everything else works great. Oil Pump Stator Fly Wheel Clutches Can Pipe Track Skis A-Arms Seat (no rips) Tunnel...

I threw a mag side rod bearing, seized the engine and cracked the blocks. So, Ive got all the part of a 2007 Dragon 700 155" x 2 1/2" track. Motor had about 2400 miles on it. Everything else works great. Oil Pump Stator Fly Wheel Clutches Can Pipe Track Skis A-Arms Seat (no rips) Tunnel...

I threw a mag side rod bearing, seized the engine and cracked the blocks. So, Ive got all the part of a 2007 Dragon 700 155" x 2 1/2" track. Motor had about 2400 miles on it. Everything else works great. Oil Pump Stator Fly Wheel Clutches Can Pipe Track Skis A-Arms Seat (no rips) Tunnel...