Where to get non carbide wear bars for the new ski's, not feeling like making them this time...
Wear bars
- Thread starter PaulAnd
- Start date
P
Take a grinder to the carbides.
It is about a 6 pack type Job to get them smoothed out to the point there they do not catch or damage your trailer and floors. it will still make them outlast straight steel bars 3 to 1
It is about a 6 pack type Job to get them smoothed out to the point there they do not catch or damage your trailer and floors. it will still make them outlast straight steel bars 3 to 1
I usually grind them, but I noticed these wear bars have carbides on the tip also, lots of grinding!
Maybe torch and weld this time
Maybe torch and weld this time
The 2017 wear bars are the same as earlier model pilot ski bars we have them in titanium if you're interested check out the website and I do have some in stock. Thank you. Dan
Dan, I dont see them on the website?
I'll take a set of steel wear bars!
I'll take a set of steel wear bars!
Are most people actually removing the carbides or grinding them down?
Sorry not steel all I do them in is titanium
N
you only have to get it loaded once, couple asphalt runs and you'll be good to go.
B
New skis are still DS3's are they not? BRP sells steel runners. $15 a pop cdn.
Woodys hardbar topstock part # hsd-9500 36.00 for the steel option
fits ds1,ds2 and ds3 ski
fits ds1,ds2 and ds3 ski
P
I grind them primary so they do not hook on rocks and secondary to save wear and tear on trailers and garage floors. The carbide will still be of use just not as aggressive and like I said before they last a lot longer when you are on the spring grave trail in runs than just straight steel. Bonus is they come with the sled with no extra charge.
