Ulmer Nytro Engine Code 35????

quadtrac · Dec 4, 2010

Took my 08 nytro out today and it was running great at about 6lbs boost. Then I let it idle for a few minutes and all the sudden it sounded like it was missing on one cylinder, and then I seen it was flashing engine code 35. I was running 50/50 avgas in it at the time. I tried to drive it around to see if it would clean out and once in awhile it would run fine. But now it I cant get it to run any better. Any Ideas? Thanks Guys!

SRXSRULE · Dec 4, 2010

Thats the code for #3 igntion coil. May have a bad coil or a loose connection. good luck. Eric

frees-tyler · Dec 5, 2010

Check to make sure the wiring harness just behind the primary clutch is not rubbing. If you remove your clutch you can see it quite easily...the harness does a 90* turn right near the front motor mount and will wear through. worth a look

Search

Ulmer Nytro Engine Code 35????

quadtrac

New member

SRXSRULE

Well-known member

frees-tyler

New member

Similar threads