Team Secondary Balancing

R

Radar78

Well-known member

Lifetime Membership

Aug 20, 2010

396

69

28

Dundurn Sask. Canada

• Nov 13, 2017

• #1

I just brought my new '16 M8000 home and I'm new to the Team clutching. Made a rookie mistake and didn't mark the sheaves on the secondary before I pulled them apart. Is it as crucial to keep them aligned as it was on the old Cat secondaries?


Sent from my iPhone using Tapatalk

 

K

kiliki

Well-known member

Lifetime Membership

Dec 27, 2008

13,213

2,398

113

Nampa, Idaho

• Nov 13, 2017

• #2

Look at the deflection screw mark on the inside of the inner chiv and align it with the outer chiv and put a marker line on the clutch halfs so you can make the alignment on shaft match

 

R

Radar78

Well-known member

Lifetime Membership

Aug 20, 2010

396

69

28

Dundurn Sask. Canada

• Nov 14, 2017

• #3

Dumb question but should the deflection screw line up with the DL stamp on the inner sheave?


Sent from my iPhone using Tapatalk

 

Last edited: Nov 14, 2017

kidwoo

Well-known member

Lifetime Membership

Dec 28, 2008

2,630

1,875

113

• Nov 14, 2017

• #4

I did the same thing when I got mine.

You should be able to see on the inner sheave where the 'slide' plates are, based on where the gouge starts.