C
I've seen a lot of posts with this problem but no feed back on solutions, sled just quit going up trail.pulled plugs to check for fire, plugs sparked once on first pull then nothing,towed home,disconnected single black and white wire to eliminate,tether ,ignition switch ,tors,checked stator resistance values,passed,pulled flywheel to check stator wires,good, pulled stator checked solder connections on back of stator good. but what I did find was remnants of a
old water pump belt wedged in between all flywheel magnets( filling the gap between magnets) removed all belt debris, reassembled, tested 1 set of spark to plugs then nothing. tested with known good coil and CPU, nothing, Any thoughts? Thinking secondary windings in stator bad, but passed RESISTANCE TO test? what gives? Thanks in advance, CRANK
old water pump belt wedged in between all flywheel magnets( filling the gap between magnets) removed all belt debris, reassembled, tested 1 set of spark to plugs then nothing. tested with known good coil and CPU, nothing, Any thoughts? Thinking secondary windings in stator bad, but passed RESISTANCE TO test? what gives? Thanks in advance, CRANK