I am working on my boys 96 phazer II and just got done installing 7 tooth drivers and an 1 1/2 track. my question is on the bottom gear on the drive shaft is it supposed to float on the shaft. I have the spacer behind it that goes between the bearing and gear. I have taken probably 100 chaincases apart and have never seen this. I did not pay any attention when I took it apart but it had to be that way previously. The idler bearing is fully seated on the other end of the shaft so the shaft is in place and where it needs to be. I even looked at a parts fiche to make sure nothing is missing and verified that everything is there that needs to be. Any help would be appreciated.
Thanks Nick
Thanks Nick