Picked up a set of drop and roll plates that are supposed to be for a Wedge chassis. My sled is 1997 XLT RMK Xtra- 10 133 with the CRC "controlled roll center" front end--My question is are the bulkheads the same between this and the Gen-II bulkheads? These plates are partially marked and not completely cut or drilled. I have a Gen-II chassis with a Holz drop and roll that uses the Wedge chaincase and relocates the jackshaft inside the tunnel. I was wondering if I could use the plates already installed on the Gen-II chassis to pattern from? TIA!