Throwing code 4-3510

[BKC850]

Hey I was wondering if anyone knows what might be the best place to start looking for the issue of code 4-3510 P06B4. It says it's the sensor supply voltage 2 low. I just wasn't sure if there might be a easy fix to this.

My kill switch is also finicky for wanting to work or not so I want sure if that's maybe the issue?

Thanks

Sent from my CLT-L04 using Tapatalk

 

[J270wsm]

I believe it’s a speed sensor fault.

 

[BKC850]

I believe it’s a speed sensor fault.

Alright thanks. I can't find much on the speed sensor location. Where abouts should I be looking


Sent from my CLT-L04 using Tapatalk

 

[BKC850]

Alright I found it...now...can I run the sled with it unplugged

Sent from my CLT-L04 using Tapatalk

 

[J270wsm]

I assume you should be able to. Unplug it and see what happens.

 

[BKC850]

I assume you should be able to. Unplug it and see what happens.

Ya I did just at idle. I would just hate it to go right to limp mode. There is 3 wires so there is something else it's going to be running with I'd assume. I don't want it to over fuel or under fuel, starve for oil or do something ridiculous off of one sensor being unplugged. Can't find one around neither.

Sent from my CLT-L04 using Tapatalk