Matryx QD protector
- Thread starter kylant
- Start date
Van Amburg makes one for the Axys - might fit the Matryx?
Or talk RPM into making one of these for the Matryx.
The Skinz Axys fit but there is a bit of trimming involved. Belly plastics are not the same . What I did was once I got the rear mounting point where the tunnel meets the bulkhead I secured it with a Kliko and made my cuts and drilled new rivet holes if that makes sense.
Sent from my iPhone using Tapatalk
Remers Renderings make a nice plate, fits well and is solid!
www.facebook.com
Remer’s Renderings | Cranbrook BC
Remer’s Renderings, Cranbrook, British Columbia. 2,345 likes · 190 talking about this. Snowmobile Accessories - Aluminum/Steel Custom Fabrication - Powder Coating - Media Blasting
www.facebook.com
Any photos? Nothing on his FB pageRemers Renderings make a nice plate, fits well and is solid!
Remer’s Renderings | Cranbrook BC
Remer’s Renderings, Cranbrook, British Columbia. 2,345 likes · 190 talking about this. Snowmobile Accessories - Aluminum/Steel Custom Fabrication - Powder Coating - Media Blasting
That is a nice piece, they have photos and a install vid on their site.
Polaris Axys/Matryx Q2 Drive Skid Plate
Add next level protection to the front end of your Polaris Matryx with our Remer's Renderings Skid Plate. Materials Used:6061 3/16 Aluminum PlateBuilding Process:Every one of our bumpers are 100% built in house in our shop located in the East Kootenay's of British Columbia, Canada. The...
www.remersrenderings.ca
I might have a set of the Skinz gaurds in stock for the AXYS. PM me if someone wants to buy them and try them. I can confirm stock tomorrow,
