My backordered Diamond Drive gasket finally showed up. I added a very thin coating of high temp sealant to both surfaces as the manual stated after putting the new double row bearing equipped assembly back into the planetary unit. The cover went on fairly well. I put in the screws and tightened all of them in a criss cross pattern but, I didn't quite go to the torque called out in the manual for fear of stripping out a screw. That screw just aft of (behind) the drain bolt hole is a SOB. I'm not sure if I got it tight enough, I got it as tight as I could with out disassembling the sled and now I am worried the case may be seeping a bit but, it may be that I tried to put the entire 15 oz. bottle of fluid in the Diamond Drive of my 09 M8 and it wouldn't fit. The oil ran down the front of the case and I bet I had a couple ounces dribble out of the case. So, I'd say my 2009 M8 case hold 12-13 ounces of Diamond drive oil, certainly not 15 ounces. Is that what you guys are seeing?
Thanks
Thanks