Is there a fix out there for the Xms that won't run with certain brands of cans? Have a buddy sled bogs and runs on one cylinder with can installed factory muffler runs like a top thx in advance.
2013 xm can issues
- Thread starter ghostrider73
- Start date
There was an update mid season for the 2015 and earlier sleds but it was more for a code than running condition. Some cans are built like junk and don't perform.
The issue is not the snowmobile, it is the can.
Some are junk, some are not. Some use a flow bench and dyno when building their cans, some just weld up a can and sell it.
HPS, Dyno-Port, Straightline Performance are all good options. Tested and proven products.
Do you buy your boots at WalMart? Or your gloves? If not why? Probably the same reason buying the cheapest can is also not a good idea....
I agree with FEZ. Etec's can be finicky when it comes to silencers. Have seen them drop 4-500 rpm with nothing but a can swap.
HPS is the only one I have personally not seen or heard of an issue. There may be others, that's just been my experience.
HPS is the only one I have personally not seen or heard of an issue. There may be others, that's just been my experience.
slp
got the slp for cooker hope it works!
so far so good
got the slp for cooker hope it works!
so far so good
Slp can
I'm running the SLP can on my xm and haven't had any issues. Not too loud and saved some weight which is a plus.
I'm running the SLP can on my xm and haven't had any issues. Not too loud and saved some weight which is a plus.
Similar threads
