R
I just installed a fresh engine in a 2001 Skidoo Summit 600. I believe that I have it fairly well aligned. I favored engine torque by setting the PTO side slightly forward.
Apparently there is an alignment tool for this, but I do not own this tool.
Are there any alternate "out-side-of-the-box" methods that you guys can suggest to me....... I.E., measurements, straight edge, off-set dimensions, etc?
Thank you in advance,
Rick E.
Apparently there is an alignment tool for this, but I do not own this tool.
Are there any alternate "out-side-of-the-box" methods that you guys can suggest to me....... I.E., measurements, straight edge, off-set dimensions, etc?
Thank you in advance,
Rick E.
Last edited: