S
my 07 m8 throws the 1:8 code, my cables were burned from the pipe so i replaced both cables and set them to the 35mm as required, i also rerouted my wires from under the tank, to in front of the tank. Got the sled all put back together and pulled it over, once i get over 5,000 rpm the i get a 1:8 flash again. I had a servo motor form an m1000 that i put on there just to see if I would get same response, and i did. idk if i am able to put the m1 servo on the m8 but they had the same wires.
Any advice on how to get this resolved?
Any advice on how to get this resolved?