Tips for Installing Seat Covers

[SnowBound]

Does anyone have any tips for installing an aftermarket seat cover. I'm installing an RSI cover on a 2012 proclimb.

 

[crashnbash]

If you wrap the foam with plastic it helps the cover slide over the foam. The best plastic I have found is the clear, cheap trash bags.

 

[West]

Just did the same thing

I just installed the same cover on my proclimb. I must have pulled it too tight because the seat wont stay clipped in on the front now.

Advise - only pull it tight enough to remove the wrinkles.

 

[SnowBound]

I actually installed it last night took about 45min start to finish. Much easier then expected. I watched a short clip on YouTube. I put the cover in the drier on low for a few minutes. It made it much easier to work with and got rid of the packaging wrinkles. This cover is better looking then the stock one and should function much better in my opinion.