X
Investigating upgrading a 2011 ST MH with a 2013 track and 7 tooth drivers.
Noticed that the Qty 2 2011 ST limit straps are cut through about 40% of their width where the track drive lugs rub on them.
Was looking at my 2016 Timbersled LT and noticed the suspension has no limit straps.
By my calculations the 7 tooth 2.86 is just slightly smaller than the 8 tooth 2.52 so just a slight increase in interference there.
Before I contact TS can anyone point me in the right direction for:
Mod the 2012/2013 update pivot arm (Single Strap) verses using the 2011 update front arm (Twin Strap) with a 2011 suspension?
Any way to use the 2016 front Pivot Arm with the the integrated 3" wheels?
I assume there is no way to delete the limit strap on a 2011 MH?
:spider:
Noticed that the Qty 2 2011 ST limit straps are cut through about 40% of their width where the track drive lugs rub on them.
Was looking at my 2016 Timbersled LT and noticed the suspension has no limit straps.
By my calculations the 7 tooth 2.86 is just slightly smaller than the 8 tooth 2.52 so just a slight increase in interference there.
Before I contact TS can anyone point me in the right direction for:
Mod the 2012/2013 update pivot arm (Single Strap) verses using the 2011 update front arm (Twin Strap) with a 2011 suspension?
Any way to use the 2016 front Pivot Arm with the the integrated 3" wheels?
I assume there is no way to delete the limit strap on a 2011 MH?
:spider: