N
Natchooo
New member
I have a Polaris 685 IQR set up. I can sell it a number of way (100% complete W/ pipe, reeds, bored 42mm carbs, electrics, oil pump, recoil, primary clutch, etc.), or for the right offers I can sell just the motor, and then other components separate.
It is 08 600ho cases with 600 ves cylinders (bored and ported) with Pro X pistons. Cases bored to match, as well as head. The head is a cut for high elevation, or a mix of 92 and 110 at low elevation.
It is a dynoport IQR pipe for the 685, vforce reeds, and bored 42mm rack carbs.
It was put together by a shop, but from what I was told is a Carl's Cycle kit. THIS THING RIPS! I have both high and low elevation jetting and clutching. For the complete turn key IQR set up I would be looking for $3000 OBO. Don't be shy. I will ship anywhere on you're dime. I'm located near the twin cities in Minnesota.
It is 08 600ho cases with 600 ves cylinders (bored and ported) with Pro X pistons. Cases bored to match, as well as head. The head is a cut for high elevation, or a mix of 92 and 110 at low elevation.
It is a dynoport IQR pipe for the 685, vforce reeds, and bored 42mm rack carbs.
It was put together by a shop, but from what I was told is a Carl's Cycle kit. THIS THING RIPS! I have both high and low elevation jetting and clutching. For the complete turn key IQR set up I would be looking for $3000 OBO. Don't be shy. I will ship anywhere on you're dime. I'm located near the twin cities in Minnesota.
