F/S Heel-X (aka HC-X) Cat roller secondary billet alum cover with two helixes.
This is the steel roller set-up, not the nylon rollers that the stock cover uses.
You can't use alum helixes with this cover. Well you CAN, but they don't last very long. LOL
I have a 46° and another one that's labeled 42/46. It's a reverse cut.
You could put an angle finder on it and figure out about what it is if you wanted to figure out what it is.
Used very little for tuning. Few miles.
I think the helixes were $50 apiece and the cover was $150 alone.
I'll list this cover, ring, the 6 allen screws and 2 helixes for $100.
This is the steel roller set-up, not the nylon rollers that the stock cover uses.
You can't use alum helixes with this cover. Well you CAN, but they don't last very long. LOL
I have a 46° and another one that's labeled 42/46. It's a reverse cut.
You could put an angle finder on it and figure out about what it is if you wanted to figure out what it is.
Used very little for tuning. Few miles.
I think the helixes were $50 apiece and the cover was $150 alone.
I'll list this cover, ring, the 6 allen screws and 2 helixes for $100.
Last edited: