**NEW Product Announcement -- Dynojet Power Commander V for the ETec 800!!**

After several Years of R&D, Dynojet is finally releasing the Power Commander V to fuel your needs for modifications on the 800cc ETec engine.

This new module has begun shipping and will fit each ETec equipped machine in the XP chassis. (The harnesses on the XM and XS are slightly different....but we will have a PCV for you guys soon....)

For those of you wishing to add pipes, intakes, big bores, and porting -- we have the answer for you providing that additional fuel. This is done without spoofing sensors thus fooling the ECM into adding more fuel...as with all of our Dynojet Products, this Power Commander setup utilizies OE wire connections plugging straight into your machine without tapping any wires.
The ECM is not reprogrammed when using the PCV either...we merely add fuel on top of what the ECM requests per given load condition.

We are only fueling N/A applications at this point.

The first 200 units have been shipped and are filling the back orders of our distributors every day.

Get in touch with us at 1-800-992-4993 or visit us on the web at www.powercommander.com for additional information or to get your order placed!
This part number is 25-015 for reference.

Thanks and Pray for Snow Everyone!

~T.J.

seanc,

No - there are no ignition changes possible with the PCV for the ETec equipped snowmobiles.
Many had said that it was Not possible to piggyback on a direct injection machine -- but we have accomplished our goal!

~T.J.

GolfPineAcres,

With this sled on a chassis dyno, by adding a small amount of fuel (not overly rich) the machine picked up 3.8HP when dropping the AFR from 15.8:1 to 14.1:1. This was on a stock machine with no modifications. Though we could continue to add more fuel, there was no additional air flowing through the engine to benefit from the over rich condition.

~T.J.