9
I got a M6 for my wife to ride. Took it out and it had alot of play in the rear of the top left a arm. Rode it that way for awhile but finally tore it down this weekend. I found out that the bushing that is supposed to be in the bulk head was not there. This is the spot where the back bolt for the top A Arm goes through the bulk head (not sure if the guy before took it out or what) With no bushing and just the bolt there was lots of play and it even caused the hole to become egged out. My question is - Could a guy get away with filling the hole with JB Weld, grind it smooth, and then redrill the hole for the bushing? or do I need to take it somewhere to get it welded up??
I am going to try and get a picture up. The new bushing does fit in the hole pretty snug. I am concerned that it will eventually work towards where the bolt (without the bushing) did the damage.
Any advice would be greatly appreciated. THanks
I am going to try and get a picture up. The new bushing does fit in the hole pretty snug. I am concerned that it will eventually work towards where the bolt (without the bushing) did the damage.
Any advice would be greatly appreciated. THanks
Last edited: