Digatron Dual EGT. Is the weld in bung a 7/16" fine thread?

10000 Lakes · Feb 17, 2013

I bought a used Speedwerx Y-pipe with the welded in bungs already welded in from what the seller told me was a Digatron Dual EGT sensor. I can't find any specs about Digatron. I know I had to buy 2 7/16" inch Fine thread brass caps to seal off the y-pipe untill I bought a EGT. Do you know what size comes on a Digatron just so I don't have to reweld? I would buy the Koso if that's what it is. Thanks.

BASHERCAT · Feb 17, 2013

brass fittings

You can just slid off the fitting and put the correct size one on you need.You'll need to replace the little collar that slides onto the probe if it doesn't slide off easily. They are cheap. At least I can change on a older digitron.Pretty simple for the diy-er.
Not letting me send pics I'll try later