Jetting on a 2000 700MM~

Ford428CJ · Dec 12, 2010

With Bender pipes. Stock reeds (from what it appears) It has 135 jets straight across. My idle screws are 2 turns out. I haven't checked to see where the needles are set at or what idle jets I have.

I ride from 5,000ft (lowest) to little over 8,000ft. Mostly 6,000 to 7,000ft is where I find myself riding. I see most 700mm riders ride up to 10,000 or below 5,000 and nothing in between.

Thanks for any advice!!!

Ford428CJ · Dec 12, 2010

What I'm asking is, what jets will work best and where to set the needle clip to?

Turk · Dec 12, 2010

I still have my bender specs.
140 mains strate across
needles #2 position

fuel screws out 2 turns

3500-7000'.

Ford428CJ · Dec 12, 2010

Thanks Turk!!!
One last Q for ya.... If I do decide to switch out the stock reeds to an after market set. What jets??? Thanks again!

Turk · Dec 12, 2010

Stock yammie reeds work very very well. Save your cash. You won,t gain anything.

Ford428CJ · Dec 12, 2010

Turk said:
Stock yammie reeds work very very well. Save your cash. You won,t gain anything.

Thanks for the heads up! Any other worth while mods for the engine?

revrider07 · Dec 25, 2010

p-85 polaris clutch form hartman, reed spacers,boost bottle, vforce reeds, bender porting, mountain performace tunnel, 151 track. The clutch was best mod for the money gained 6mph track speed.

Ford428CJ · Jan 3, 2011

revrider07 said:
p-85 polaris clutch form hartman, reed spacers,boost bottle, vforce reeds, bender porting, mountain performace tunnel, 151 track. The clutch was best mod for the money gained 6mph track speed.

My plan is a 151-156 track with a Fabcraft Tunnel, Jaws pipes with a Union Bay 944 kit. We will see...... Just need some $,$$$.$$ LOL

Search

Jetting on a 2000 700MM~

Ford428CJ

Well-known member

Ford428CJ

Well-known member

Turk

Free Member

Ford428CJ

Well-known member

Turk

Free Member

Ford428CJ

Well-known member

revrider07

Well-known member

Ford428CJ

Well-known member

Similar threads