Getting ready to start on my nytro back half and Im needing a dimension from somewhere I can refrence the front and rear factory suspension hole locations. I have an aftermarket tunnel and am unsure if the front is in the OEM position or not and I know the rear isn't. Maybe from the center of drive shaft to center of holes, and top of tunnel down? Or maybe from edge of bulkhead?
NEED NYTRO TUNNEL/SUSPENSION MEASUREMENTS
- Thread starter n2otoofast4u
- Start date
31.5" Center of front hole to Center of rear hole. If I remember correctly. Somebody confirm this it has been a while since I messed around with this.
Anyone have a way to reference the factory front bolt hole location?
Common fellas. Someone has to own a tape measure and a few minutes they can spare to give me a measurement to an OEM front mounting hole.
