K
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Sorry for the delay I just got a chance to post some pic's.
If the price is right, I would take one. I hate electrical and dont want to wire up my bosch.
The m7 has 2 little case nubs on each side of the oil pump that are not used for anything so a person would have to cut down the first one on the mag side closest to the oil pump. The m8 & 1000 have two motor mount studs on the mag side also but the pump will clear them but you may have too relocate the motor mount that just bolts on. :face-icon-small-hap
How fast does the oil pump spin? Oil doesnt come gushing out when that is running, because I have mine oiling my turbo. Also, I am assuming the shaft has a small propeller on it to move the water? Maybe different sizes/ designs of the propellors may work?
And I think you may want a bigger cooler to help with heat transfer, it may not be the speed of the flow but surface area. It looks like your cooler is just a single run of aluminim pipe?
What size are the electric pump inlet and outlets?
What size are your inlet and outlets? 1/2"?
Let us know as soon as you get an answer, hopefully before some vendor uses your idea and marks it up...
The pump is a direct drive to the oil pump. I have my oil pump running my turbo oil supply also so the pump drives at the stock RPM. As far as the flow and heat exchanger the one I use is to a 500 snopro so if it keeps a 500 engine cool it should work fine for the intercooler. I am going to install a valve to modulate the water flow until I find a temp I want to run and then install a flow orifice and yes they are 1/2". should work.
Cheers:tea:
I hope to get some pricing soon so I can fill you all in. When I put this pump together I set up a drive shaft to run off
my dewalt 18V cordless drill and on high speed it shot out a solid stream 1/2 dia about 10 feet and washed down my posters on the wall :face-icon-small-hap. I know it was not a technical test but with that volume I think it will be fine for what we want it for.
Cheers
I to work with radiant heat and cooling through ground source and also do HVAC. I have been working with this set up and I totally agree with you about heat transfer. That being said I am working with parts mainly like the 500 sp tunnel cooler for cost if I want to produce these sleds and they do work quit well for this build. Time will tell just how well but I am sure I will be very pleased:face-icon-small-hap