SnoWest Snowmobile Forum - View Single Post - Low Profile, Billet Power Valve Housings
View Single Post
  #1  
Old 12-08-2017, 07:03 PM
speedysprocket speedysprocket is offline
Currently: Not set.
Join Date: Jan 2012
Basic Member
Age: 31
Posts: 17
Thanks: 0
Thanked 3 Times in 2 Posts
Rep Power: 0
speedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant futurespeedysprocket has a brilliant future
Default Low Profile, Billet Power Valve Housings

Not sure if there’s much market for these. I came up with this because of exhaust clearance issues with running the 2002-2005 800 based cylinders in jet skis.
These will fit the 02-05 800 and the big bore cylinders The Crank Shop makes and possibly others years/models that use that same stock housing. You can replace those big, ugly stock housings with these billet housings and caps. All parts needed are included. You will just have to send your valves in to be cut down to fit. Please let me know if there’s any interest. Was looking to do $200 for a pair.
Attached Images
   
Reply With Quote


2 out of 2 members found this post helpful. Rate this post: Yes | No
The Following 2 Users Say Thank You to speedysprocket For This Useful Post:
MrIQR (01-10-2018), TRS (12-08-2017)