Just doing a some yearly check up with my bore scope. Here is what the backs of my cylinders are looking like on my turbo sled. The motor is a fresh rebuild as of last year by SHR. It was easily twice the turbo sled after BJ and friends sent it back. I did however have a problem with my fuel controller and experienced a few lean runs and pops. Does this look like serious damage or am I being too paranoid? I did finally figure out the fueling problem. A bad RAVE sensor was shorting out my electronics. Fixed that at the end of last year and everything is back to being peachy. Compression is still spot on.
Any advice is appreciated!
Any advice is appreciated!