R
I'm having trouble keeping it idling after reving up,timing is on,TPS reeds 16-95,no air leaks,I missed with the idle nob,and it doesnt make any diff, is there anything I'm over looking.
T apex wont say idling after letting of throttle
- Thread starter relentless rider
- Start date
R
Just put used BD turbo kit on,with head shim with gasket on each side.I'm running a fastraxx fuel box,with idle fuel set on 2.never had any problems when it was stock only 1300 miles.I'm thanking that it might have something to do with the idle nob and the four little screws on top of throttle bodies,because i tried adjusting to make it run better,and forgot to mark them,when my timing was off the first time i was having troubles.thanks for any help!!
T
You need to check all the lines that are on the vacuum side of the throttle bodies. If you have one unplugged, it can give you idle related issues.
R
How do i adjust the idle nob,and the four little screws on the top,i thank this is my problem.thanks
T
are you running a fuel regulator? if so did you set it to 43 lbs of pressure with the sensor line disconnected. if you set it to 43 lbs pressure when it is hooked up the sled won't idle proper.Also did you tie strap all your lines on the fuel rail?
I was having the same trouble on one I just did and it ended up being timing.
R
Its leaving a code 14,if i take the intercooler off it,and fuel box off, it runs good and idles fine!
Last edited:
S
if you mess with the 4 little screws you will have to re balance the cylinders they are matched to flow the same cfm at idle.
R
How do i do this? i am thanking this is my problem. thanks