replate cylinders

[700modsled]

Was wondering who you guys send off your cylinders to get renicasiled? cheapest I found was USNICOM and they want $200 per cylinder.

 

[sled_guy]

I use Langcourt in Alabama... have always liked their work.

http://www.langcourt.com/

sled_guy

 

[Island Rider]

hardass has replated jugs for polaris he is awsome to deal with. I purchased 2 from him and am very happy with them .

 

[700modsled]

how do i get in touch with hardass?

 

[Ex-Member]

Just got mine back from Millenium Tech yesterday. Little over $200 shipped.

 

[700modsled]

for two cylinders? or $200 per cylinder?

 

[Island Rider]

://www.snowest.com/forum/showthread.php?t=133568s this the add that hardass has in the engine section of the swapmeet , i will se if i post it .

 

[700modsled]

Do I have time left on thees jugs? there are a few ring scuffs that your fingernail catches. not too deep though. no nicasil flaking off. im tempted to send them off to get replated but dont want to if i dont have to.

 

[suitcase]

Millenium, is top of the line for renicklen your jugs. Not to sure it has been a while sence ive had one done but i'm almost sure it was 170 per? The pic of the jug above looks like you could get a few more out of it. They my go for an other 1000 and never give you a lick of troble. If it was mine I would send it off to Millenium. Then there is no worries about getting towed.


Just my two penny's

 

[OntheGasHard]

Millenium is the best I have used for yearing on my watercraft, snow and Dirtbike stuff.
I just got 5 cylinders back today 2 for my rmk 800 and 3 more rmk 800 cylinders that im going to run on my polaris 1200 watercraft.

YOU GET WHAT YOU PAY FOR............

 

[SnowXTC]

Langcourt did mine and I am very happy with them. I sent the new pistons with so that they could match them with the pistons.