S
I'm troubleshooting some issue with the fuel system. I would like to run the fuel pump to check for flow and pressure while it's in the sled.
Does anybody know if I put +12V on Pin 5 and Gnd on Pin 3 of the COM connector, with the DESS key connected, will the fuel pump run? This is a SHOT sled if that makes any difference (but I don't think it should).
Does anybody know if I put +12V on Pin 5 and Gnd on Pin 3 of the COM connector, with the DESS key connected, will the fuel pump run? This is a SHOT sled if that makes any difference (but I don't think it should).
