Polaris Clutch on Arctic Cat?

[Ausm7499]

I tried to get some imput about this in the AC forum but nobody replied so I thought I would try here. I broke the primary clutch on my 08M1k and don't want to buy another AC clutch because they don't make any replacement parts for them. I am thinking about buying a P85 Polaris clutch and having it machined to a 35mm taper so I can run it on my sled. Has anybody done this or have any better ideas as far as replacement clutches. Any prior experience or advice would be great.

 

[Anylizer]

I'm not 100% positive , but I don't believe there is enough steel in the p-85 to machine it out to fit the cat crank.

 

[Ausm7499]

I don't know this for certain but I have been told the taper on the Polaris 800 clutch is a 33mm. The taper on my Cat is 35mm I would think that there is enough material to remove a milimeter worth of diameter. Please correct me if I am wrong on the Polaris taper.

Also does anybody have one of these clutches that they would be willing to sell.

 

[Tri-J]

I don't know this for certain but I have been told the taper on the Polaris 800 clutch is a 33mm. The taper on my Cat is 35mm I would think that there is enough material to remove a milimeter worth of diameter. Please correct me if I am wrong on the Polaris taper.

Also does anybody have one of these clutches that they would be willing to sell.

800cfi's are 32 or 33,
2000-2005 800's are 30mm...

I was thinking the Cat's were 33mm and the 800cfi was 32mm... Are the 1000 35mm???

 

[Ausm7499]

Yes the M1000 is a 35mm.

 

[Hardass]

So is this all there is on the subject?

 

[TheBreeze]

Fastrax is offering a plug and play P-85 setup for the Cats. Maybe contact him.

 

[FTXMOTORSPORTS]

here is a link with more info ...

http://www.snowestonline.com/forum/showthread.php?t=255809

feel free to call or P.M. if you have more questions

Curt