Pictures of anti stab kit on a pro?

[Sunvang]

Made my own anti stab kit the other day, with a wheel on each side of the front straps (I got two to prevent the rails to bend), but discovered that the wheels hits the taps where the non-slips grip on the track.

Anybody got a picture of anti stab kit mounted on the rails? Need opinions and ideas.


Thanks.

 

[Snodawg]

Is this needed with a 2.86 track? I thought it was just the 3.00 pitch that needs them.

 

[Sunvang]

I mounted non-slip wheels, and needed to cut the rails so they would be clear of the non-slips, so yes I need anti stab kit

 

[Sunvang]

Nobody mounted a anti stab kit or non-slips that can help me out?

 

[d8grandpa]

here is some pics of my set. make sure when you cut your rails so they are shorter than the travel line of the wheels. also use loc tite on the bolts.a bolt came loose and I lost one wheel before I realized I stabbed a new track, replaced wheel but rails were too long only by about 1/2" , track was a little loose and stab 2nd new track. costly lessons! works good now though.

 

[Sunvang]

Thanks for the pictures They will be very helpfull!

 

[IQRIDR]

I have done the anti-stabs both ways...with and without the rail tips reinstalled. I tend to shave down the rail tips and reinstall them just so in case an outer wheel comes off, the track can still slide on the tip instead of catching a sharp metal rail on a track clip.

I have also had people question me for reinstalling the tip. The rail does need to be cut more than 1/2" when reinstalling the tips though...closer to 2" cut off. Does anyone see a down side to this?

 

[Richracer1]

Here's the anti-stab kit I got from SLP for my '09 RMK (is the Pro any different???). The rails are IceAge and trimmed to run Avid drivers so I don't know if it's different in regards to the stock rails.

With the track:

With out the track: