P1324, P0264 injector wires breaking..

[summ8rmk]

Anyone get this lovely code?
Knock control system activated.
Just enough power to get sled up the ramp.
Sounds like a 4stroke, power of a one cylinder 200cc engine.



Sent it

 

[summ8rmk]

Followed by P0264 cylinder 2 injector circuit low

Sent it

 

[summ8rmk]

I figure it's either a bad injector, wire shorted or bad ECM.
I don't know how to test the injector.

Sent it

 

[ak]

I had that code once, it limited my top end but I shut it off, restarted and ran fine . Shortly after I did have to replace my pipe sensor but don’t know if it was related.

 

[summ8rmk]

I am definitely having fueling issues.
Mag side is dry.
Checked ohms at the injectors pigtail.
#1 100ohms, #2 11.9ohms...

Sent it

 

[summ8rmk]

Simple problem. Broken wire.
Now if i can figure out how to disassemble the connector i can repair it.?

 

[summ8rmk]

Soldered back together.

Both injectors are 11.9 ohms. After fixing harness, they both ohm 11.9 at the end of the harness also.
If u have any issues like this, just unplug the harness behind the muffler and check ohms. Yellow is MAG side and green is PTO.

Sent it

 

[Chewy22]

Soldered back together.

Both injectors are 11.9 ohms. After fixing harness, they both ohm 11.9 at the end of the harness also.
If u have any issues like this, just unplug the harness behind the muffler and check ohms. Yellow is MAG side and green is PTO.

Sent it

how was it getting the pin out of the plug?

 

[summ8rmk]

how was it getting the pin out of the plug?

Not to bad when i figured out that it has 2 locking tabs.

Sent it

 

[clutch]

Thanks for the info!

 

[Wapow]

Beauty solder job! I need to get one of those wire holder thingies.