• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

Kurt's Gear down with 8 tooth drivers for Axys 2.6

Stroker Customs

Well-known member
Lifetime Membership
Jan 17, 2002
488
94
28
CO
I have put a couple of these kits together if anyone is interested. They are a final gear ratio of 2.38 with stock 8 tooth 2.86 pitch pro drivers. These are a direct bolt on for the axys 2.6" sleds. No modifications needed and use the big hex drive shaft $650 a kit.
 

goridedoo

Well-known member
Premium Member
Feb 8, 2010
3,868
3,544
113
What benefits have you seen in going to the 8 tooth drivers?
 

Stroker Customs

Well-known member
Lifetime Membership
Jan 17, 2002
488
94
28
CO
Better rolling resistance, better attack angle, main difference is in the tight trees the sled doesn't trench as bad. The track pulls the sled forward when in a sketchy area instead of blowing out like a stock setup. So say you have a single trail through the trees in a sketchy spot and don't want to ruin the track for the people behind you the 8 tooth drivers don't seem to blow the trail out when trying to creep. Do loose a little tunnel/bulkhead clearance but no more than the 3" equipped sleds with 7 tooth drivers. You can feel the sled roll easier on downhills and deceleration where a stock one is almost like applying the brakes. Hope this helps.
 
Last edited:
Premium Features