• Don't miss out on all the fun! Register on our forums to post and have added features! Membership levels include a FREE membership tier.

Installation and Review: Simmons Gen III Flexi-Ski

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
Last May I placed an advance order for a pair of the Simmons Gen III Flexi-Skis for my Yamaha Nytro after having heard some wonderful comments from test riders who had access to prototype versions last winter.

Today, my order arrived!
 

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
As with most good things, the skis arrived in a plain brown box!
picture.php


Skis came with NO packing material, just slid into the box.
picture.php



One thing that really surprised me is that there is NO documentation of any kind. Not so much as a note from Simmons, just the box and the skis.
 

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
In the box were 2 mirror image skis.
I say mirror image as they are identical, but OPPOSITE.
They is a Left ski and a Right ski!
picture.php


And the two skis are CLEARLY marked so there is no mistaking which one goes on which side of the sled.
picture.php
 

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
The bottom of these skis is clearly what sets them apart from everything else on the market. They have dual keels that are Asymmetrical, which is why the skis are labeled Left and Right.
picture.php


picture.php
 

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
Yamaha OEM Ski
picture.php


New Simmons Gen III Ski
picture.php


Total Weight Gain = 2.2lbs PER SKI

So about 4 and a half pounds more on your sled.
 
Last edited:

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
Next I will get the old skis off the sled and mount the new ones.
This weekend I should have 3 days of on trail and off trail riding at the SnoWest Forum ride in West Yellowstone to TRY out these new skis.
 

Scott

Scott Stiegler
Staff member
Lifetime Membership
Nov 1, 1998
69,618
11,737
113
51
W Mont
So when they are mounted is the short keel on the inside or the outside?
 

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
Sled the sled lift in and jacked her up a couple inches off the ground to remove the OEM skis.
picture.php


The OEM ski comes off with very little effort.
picture.php
 

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
With the OEM ski off the sled, the rubber bushing has to be removed to be used on the Simmons.
picture.php


Nut comes off and the bolt slides out
picture.php


And the OEM Bushing drops right into place.
PAY ATTENTION when you do this, as the bushing is NOT symmetrical!
Make sure you insert it in the same orientation that you took it out of the OEM skis or you will end up doing this whole process twice like I did!
picture.php
 

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
With the use of the Sled Lift I slowly lowered the spindal back down into the bushing only to find that it did not fit.

With both skis the new cradle was about 2mm too narrow so the original mounting shaft would NOT fit down inside the ski. A gentle tap with a hammer opened both of them up wide enough to allow it to slide into place smoothly.

picture.php


picture.php


picture.php
 
Last edited:

christopher

Well-known member
Staff member
Lifetime Membership
Nov 1, 2008
81,403
27,152
113
Rigby, Idaho
With both skis mounted I quickly noticed that all was not well.
The Left ski was almost perfectly flat, while the right ski was 15 Degrees tip up.

picture.php


I removed both skis, took out the rubber bushings and rotated both of them 180 degrees and remounted the skis. This left both skis with about a 5 degree Tip Up orientation.
picture.php
 
Premium Features